P0082 Fault Code

P0082 OBD-II Trouble Code Short Description

Intake Valve Control Solenoid Circuit Low (Bank 2)

What does trouble code P0082 mean?

P0082 is a diagnostic trouble code (DTC) that indicates a low voltage condition in the intake valve control solenoid circuit on Bank 2 of the engine. This means that the Engine Control Module (ECM) has detected a problem with the solenoid responsible for controlling the intake valves on the second bank of cylinders in the engine.

The intake valve control solenoid is responsible for regulating the flow of air into the engine's combustion chambers. A low voltage condition in the circuit can be caused by a faulty solenoid, damaged wiring, or a poor connection. This can result in improper air intake, affecting engine performance and fuel efficiency.

To resolve the P0082 fault code, the following steps can be taken:

  1. Inspect the wiring and connections related to the intake valve control solenoid on Bank 2.
  2. Test the solenoid for proper operation and replace it if necessary.
  3. Clear the fault code using a diagnostic scanner and test drive the vehicle to ensure the issue has been resolved.

By addressing the root cause of the low voltage condition in the intake valve control solenoid circuit, you can prevent further damage to the engine and restore optimal performance to your vehicle.

Symptoms

What are the symptoms of the P0082 code?

  • Check Engine Light is illuminated
  • Decreased engine performance
  • Rough idling
  • Poor fuel efficiency

Causes

What causes the P0082 code?

P0082 - Intake Valve Control Solenoid Circuit Low (Bank 2)

  • Faulty intake valve control solenoid
  • Intake valve control solenoid harness is open or shorted
  • Intake valve control solenoid circuit poor electrical connection

Possible Solutions

How to fix P0082?

P0082 - Intake Valve Control Solenoid Circuit Low (Bank 2)

Possible causes for this fault code include:

  • Faulty intake valve control solenoid
  • Intake valve control solenoid harness is open or shorted
  • Intake valve control solenoid circuit poor electrical connection

To fix the P0082 fault code on a car, you can try the following steps:

  1. Check the intake valve control solenoid for any visible damage or corrosion.
  2. Inspect the wiring harness connected to the intake valve control solenoid for any signs of wear or damage.
  3. Make sure all electrical connections related to the intake valve control solenoid are secure and free of corrosion.
  4. If necessary, replace the intake valve control solenoid or repair any damaged wiring or connections.
  5. Clear the fault code with an OBD scanner and test to see if the issue has been resolved.

If the issue persists after attempting these steps, it may be necessary to seek assistance from a professional mechanic for further diagnosis and repair.